Explore Project Topics on: DESIGN AND CONSTRUCT A VERTICAL SINGLE-AXIS SOLAR TRACKER

ABSTRACT This work is on a dual axis solar tracking system. The altitude angle and azimuth angle of the sun are changing all the time. The dual-axis tracking device tracks the sun to collect more solar energy. A dual-axis tracker can increase energy by tracking sun rays from switching solar panel in various directions. This solar panel can rotate... Continue Reading

ABSTRACT This project involves a design of sun tracker for PV system. The circuit of the sun tracker is designed in such a way that it follows the track of the sun as it travel in the sky. The LDR are connected to noninverter input of the operational amplifier whose reference voltage resistor R1 and R2 is 10Ω each. At the output of the... Continue Reading

ABSTRACT The purpose of this project is to design and construct a car tracker system with code using GSM. A good car attracts everyone including thieves. When it comes to the safety of cars, car owners should be very careful. These days, the market is flooded with many safety devices. Typically, the most successful ones among all is the... Continue Reading

CHAPTER ONE INTRODUCTION 1.1Background Information Electricity is a general term comprising of a variety of phenomena resulting from the presence and flow of electric charge. These include many phenomena, such as lightning, static... Continue Reading

CHAPTER ONE INTRODUCTION 1.1 Background Information Electricity is a general term comprising of a variety of phenomena resulting from the presence and flow of electric charge. These include many phenomena, such as lightning,... Continue Reading

ABSTRACT Microcontroller based remote control system is a project design of a system that uses infra red transmission and reception principle to switch on or off other appliances. It is a wireless mode of switching appliances to a desired state. When a number is pressed in the transmitter section, the receiver section decodes the signal and... Continue Reading

ABSTRACT Microcontroller based remote control system is a project design of a system that uses infra red transmission and reception principle to switch on or off other appliances. It is a wireless mode of switching appliances to a desired state. When a number is pressed in the transmitter section, the receiver section decodes the signal and... Continue Reading

Abstract The increasing accessibility to internet resources has made several companies adopt the use of such resources in their processes. Axis Human Capital Limited, a human capital management and development company in Ghana, needed a mobile application that mitigates the problems that their clients face when using their website and has other... Continue Reading

ABSTRACT Online ATM Card request and delivery system with tracker is a system designed to assist bank customers and financial institutions computerize the process of customers requesting for Automated Teller Machines (ATM) cards and verifying the customers’ records with an embedded tracker to speed up the process considering the problems faced... Continue Reading

CHAPTER ONE INTRODUCTION 1.1   Background of Study This chapter gives an overview of thisproject titled a queue management system (microcontroller based intelligent queue management system). This report started with the background of our study to give the readers an idea of what this project is all about before going into its technical details.... Continue Reading

ABSTRACT The aim of this study is to fabricate a solid ankle cushion heel (SACH foot) and comparison of the differences and effect of this SACH foot on the cardiovascular responses and gait efficiency of fifteen unilateral transtibial amputees with foreign SACH foot and Single axis foot. The SACH foot was fabricated using available local... Continue Reading

CHAPTER ONE 1.0 INTRODUCTION This project gives the insight on the design and construction of a transmission power line vandalism detector system. Vandalism means destructive action. It is a hateful and deliberate defacement/destruction of somebody else’s property or national assets like thehigh-voltage transmission power lines, transmission... Continue Reading

Abstract This project work centered on construction of 12V/10A solar charge controller that is needed in photovoltaic system to safely charge regulate and discharge of sealed lead acid battery through DC load. Solar charge controller is devices that regulate solar photovoltaic power and prevent overcharging, over discharging or overflow of current... Continue Reading

Abstract This project work centered on construction of 12V/10A solar charge controller that is needed in photovoltaic system to safely charge regulate and discharge of sealed lead acid battery through DC load. Solar charge controller is devices that regulate solar photovoltaic power and prevent overcharging, over discharging or overflow of current... Continue Reading

Abstract Over the years, we have had complaints of people copying someone else’s project directly as his/her own. Therefore, this project is aimed at solving the problem of copyright as identified during seminar presentations, project defense etc in schools. To solve the above mentioned problem, this application is developed to capture relevant... Continue Reading

(A CASE STUDY OF COMPUTER SCIENCE LABORATORY) ABSTRACT This Project entitled “DESIGN AND IMPLEMENTATION OF SOLAR POWER BANK” was designed to expose the participants to the practical skills needed in designing a solar power bank. The specification of the solar system is: Solar Panel, Mounting... Continue Reading

TABLE OF CONTENTS TITLE PAGE .. ii DEDICATION .. iv ACKNOWLEDGEMENTS . v TABLE OF CONTENTS . vi LIST OF FIGURES . viii ABSTRACT . ………ix CHAPTER ONE .. 1 INTRODUCTION .. 1 1.1              Background to the Study . 1 1.2        The Sun and the nature of light Energy . 3 1.3        Solar lamp . 4 1.4        Solar... Continue Reading

ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading

CHAPTER ONE INTRODUCTION 1.1       Preamble A power inverter, or inverter, is an electronic device or circuitry that changes direct current (DC) to alternating current (AC). ( The Authoritative, 2000 ). The input voltage, output voltage and frequency, and overall power handling depend on the design of the specific device or circuitry. The... Continue Reading

ABSTRACT Researchers suggest that the amount of sunlight that strikes the Earth's surface in an hour and a half is enough to handle the entire world's energy consumption for a full year. Solar power system is one of the best renewable energy technologies which is not only cost effective but environment friendly as well.This study aimed at... Continue Reading

ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller. These were assembled together with necessary protective... Continue Reading

ABSTRACT The 200W solar system was determined by load assessment, solar panel number determination, battery requirement and then inverter sizing. A complete solar panel rated at 200w was however purchased, together with 2 no. 150A solar battery, 1500W inverter and also 10A charge controller.... Continue Reading

ABSTRACT In this project work, we are mostly concern about building a simple power streetlight which is automatically operated. There are four main components required to build a solar operated streetlight. The solar array, High efficiency D.C lamp section made by transistor, resistors, and the sensor LDR, changes controller which is made up of... Continue Reading

Abstract A solar ovenis a device that converts solar energy into useful heat in a confined space (oven chamber) which can be utilised for cooking and baking purposes.The oven consists of plane reflectors to concentrate the solar radiation on the collector.The heat gain is maximum if the collector and reflectors are continuously adjusted such... Continue Reading

ABSTRACT Solar energy being transmitted from the sun through space to earth by electromagnetic radiation must be converted to heat before it can be used in a practical heating or cooling system. Solar energy collectors, the devices used to convert the suns radiation to... Continue Reading

ABSTRACT Solar energy being transmitted from the sun through space to earth by electromagnetic radiation must be converted to heat before it can be used in a practical heating or cooling system. Solar energy collectors, the devices used to convert the suns radiation to heat, usually consist of a surface that efficiently absorbs radiation and... Continue Reading

Content Pages DECLARATION ii ACKNOWLEDGEMENT iii DEDICATION iv TABLE OF CONTENT v CHAPTER ONE Introduction 1 1.1 Background of the Study 1 1.2 Problem of Study 2 1.3 Objectives of Study 3 1.4 Scope of Study 3 1.5 Significance 4 CHAPTER TWO Literature Review 5 2.1 Introduction 5 2.2 Types of Street Lights 6 2.3 Photovoltaic Effect/Process 9 2.4... Continue Reading

Content   Pages   DECLARATION ii ACKNOWLEDGEMENT iii DEDICATION iv TABLE OF CONTENT v CHAPTER ONE Introduction 1 1.1 Background of the Study 1 1.2 Problem of Study 2 1.3 Objectives of Study 3 1.4 Scope of Study 3 1.5 Significance 4 CHAPTER TWO Literature Review 5 2.1 Introduction 5 2.2 Types of Street Lights 6 2.3 Photovoltaic Effect/Process 9... Continue Reading

Content Pages DECLARATION ii ACKNOWLEDGEMENT iii DEDICATION iv TABLE OF CONTENT v CHAPTER ONE Introduction 1 1.1 Background of the Study 1 1.2 Problem of Study 2 1.3 Objectives of Study 3 1.4 Scope of Study 3 1.5 Significance 4 CHAPTER TWO Literature Review 5 2.1 Introduction 5 2.2 Types of Street Lights 6 2.3 Photovoltaic Effect/Process 9 2.4... Continue Reading

ABSTRACT Cell phones need electric sources to charge their batteries in order to work, but there are people in developing and third world countries that find it hard to access electric sources.In an attempt to provide an alternative means of charging to those unfortunate areas in third world and developing countries, a solar powered cell phone... Continue Reading