Explore Project Topics on: CONSTRUCTION DEMONSTRATION OF PRESSURE IN LIQUID

ABSTRACT This research work presents the static analysis of short cylindrical shell under internal liquid pressure with various boundary conditions and aspect ratios. Improved fourth order finite difference method was employed for the analysis and a MATLAB computer program was developed based on the matrix equations and models generated from the... Continue Reading

ABSTRACT The journal bearing demonstration rig is an apparatus which is used to study how pressure would vary around the section of a journal bearing at various speed of the shaft and loading conditions. The design of the journal bearing was done by the use of standard design procedures carefully stated within this work. The frame, the journal... Continue Reading

ABSTRACT The effect of liquid flow rate, pipe size (diameter) and pipe orientation (inclination) on liquid hold-up was investigated. Liquid flow rate between 500 STB/day and 5000 STB/day was studied. An oil of 25˚API at an average temperature of 175˚F, a gas gravity of 0.65, water cut of 25% with water gravity of 1.07 and containing no free gas... Continue Reading

CHAPTER ONE 1.0     Introduction 1.1     Background of the Study           The number of people with high blood pressure is in the increase and research has shown that this condition is heightened by overweight of the patient. That is to say, the more one increases in weight, the higher the tendency of him or her becoming... Continue Reading

Table of Contents Acknowledgement Approva1~ Dedication Declaration: . Thanks for your opinions and Suggestions through out this research iv Table of Contents v Table of acronyms viii TABLE OF FIGURES ix ABSTRACT: CHAPTER ONE 1.0 Introduction 1 1.1 Background 4 1.1.1 Computer Graphics 4 1.1.2 Insecticide treated mosquito nets 5 1.1.3 KeyTerms 6 1.2... Continue Reading

ABSTRACT The refurbishment of the fluid flow demonstration unit was carried out in the Chemical Engineering pilot plant laboratory of the Institute of Management and Technology Enugu. The refurbishment process was carried out to ensure adequate functioning of the unit, to allow the continuous use of equipment in the pilot plant, so that student... Continue Reading

ABSTRACT The refurbishment of the fluid flow demonstration unit was carried out in the Chemical Engineering pilot plant laboratory of the Institute of Management and Technology Enugu. The refurbishment process was carried out to ensure adequate functioning of the unit, to allow the continuous use of equipment in the pilot plant, so that student... Continue Reading

ABSTRACT The refurbishment of the fluid flow demonstration unit was carried out in the Chemical Engineering pilot plant laboratory of the Institute of Management and Technology Enugu. The refurbishment process was carried out to ensure adequate functioning of the unit, to allow the continuous use of equipment in the pilot plant, so that student... Continue Reading

ABSTRACT The refurbishment of the fluid flow demonstration unit was carried out in the Chemical Engineering pilot plant laboratory of the Institute of Management and Technology Enugu. The refurbishment process was carried out to ensure adequate functioning of the unit, to allow the continuous use of equipment in the pilot plant, so that student... Continue Reading

ABSTRACT Many methods and tactics have been deployed in the teaching and learning of mathematics yet only very few students put their interest in the subject. The research is aimed at using the computer assisted instruction (CAI) method to arouse the interest of the students in learning the subject of mathematics. The researcher takes on a... Continue Reading

In contemporary times, the relevance of an improved vocational training in the social, economic and political development of persons with or without disabilities cannot be overemphasized. In view of this, every nation should place emphasis on vocational training, especially those with hearing impairment because of the nature of their disability.... Continue Reading

In contemporary times, the relevance of an improved vocational training in the social, economic and political development of persons with or without disabilities cannot be overemphasized. In view of this, every nation should place emphasis on vocational training, especially those with hearing impairment because of the nature of their disability.... Continue Reading

CHAPTER ONE INTRODUCTION 1.1      Background of study The demonstration methods on teaching and learning chemistry in senior secondary school in some selected schools in Enugu urban, Enugu state.         The performances of chemistry students in senior school chemistry examinations is of great concern to many people in Enugu urban.... Continue Reading

ABSTRACT This research project was carried out principally for the production of liquid and vapourized perfumes from local raw materials.  The local raw material were subjected to various processing conditions in order to obtain purified perfume.  The methods generally used in this work include expression steam distillation and solvent... Continue Reading

DESCRIPTION The Liquid soap business plan is a comprehensive business plan that will assist you with all the needed ideas and plans to start a successful Liquid soap production business. The Liquid soap business plan shows you liquid soap making procedure and ingredients and in raising capital for your liquid soap business. liquid soap making... Continue Reading

CHAPTER ONE INTRODUCTION 1.1 BACKGROUND OF STUDY The level of education has increase overtime with improved method of teaching and demonstration in most secondary schools today in Nigeria. Over the years, there have being an increased rate of poor performance in chemistry due to inexperienced teachers and the unavailability of instructional... Continue Reading

Comparative Effect Of Simulation And Demonstration Methods Of Instruction On Students’ Academic Performance In Business Studies At Junior Secondary School Level. 45 This study focused on the “Effect of Simulation and Demonstration teaching methods on Junior Secondary School Students’ Performance in Business Studies”. Five research... Continue Reading

ABSTRACT  The aim of this research work is special formulation of liquid detergent for car wash. In manufacturing liquid detergents, selection of raw materials is been considered as the first step. These raw materials were selected on the basis of several factor such as human and environmental safety, cost compatibility with other ingredients and... Continue Reading

ABSTRACT A project was carried out to produce high quality liquid air refreshner for domestic uses. The project was carried out using the following apparatus. Beakers (250ML), one conical flask, hydrometer, thermometer, two – 5ml of measuring cylinders, one reactor (plastic reactor), stirrer, weighing balance. The chemicals used in the... Continue Reading

ABSTRACT A project was carried out to produce high quality liquid air refreshner for domestic uses. The project was carried out using the following apparatus. Beakers (250ML), one conical flask, hydrometer, thermometer, two – 5ml of measuring cylinders, one reactor (plastic reactor), stirrer,... Continue Reading

ABSTRACT Lemon grass (Cymbogon citratus) is an abundant, locally available plant. In this work, essential oil was extracted from it using solvent extraction method.  In this work two methods of extraction was used, solvent extraction and enfleurage methods were used to extract essential oil from lemongrass. Solvent extraction method yielded 2.08%... Continue Reading

ABSTRACT Every Natural gas well ceases producing as reservoir pressure depletes. The usual liquid presence in the reservoir can cause further problems by accumulating in the wellbore and reducing production even more. There are a number of options in well completion to prevent liquid loading even before it becomes a problem. Tubing size and... Continue Reading

ABSTRACT Monitoring and maintenance is a continuous process in the various phases of a well’s life. One of the essential part of monitoring is well testing. Just as a regular medical checkup is advised for humans so is well testing advised for a target formation. Well testing provides a means of obtaining information about the well and the... Continue Reading

ABSTRACT The research focused on the impact of child abuse on pupils’ academic performance. A case study of Kibuli Demonstfation School in Kampala District and was guided by three objectives namely;to establish the effect of Physical abuse on pupils’ academic performance ,to find out the effect of Sexual abuse on pupils’ academic performance... Continue Reading

ABSTRACT The objective of the work is the catalytic conversion of waste plastics into fuel oil and solid wax using Ca(OH)2 and the design of pyrolysis reactor. Plastic wastes such as, polypropylene, low density polyethylene, high density polyethylene, polystyrene are the most frequently used in everyday activities and disposed of to the... Continue Reading

ABSTRACT The objective of the work is the catalytic conversion of waste plastics into fuel oil and solid wax using Ca(OH)2 and the design of pyrolysis reactor. Plastic wastes such as, polypropylene, low density polyethylene, high density polyethylene, polystyrene are the most frequently used in everyday activities and disposed of to the... Continue Reading

A BSTRACT Today, millions of people in the world are without food especially in the developing world which has been of great concern as stipulated in the United Nations millennium development goal 1, sub-targets A, B and C to fight hunger, povertyand starvation across the world and ensure environmental sustainability(UNCSD, Aug, 2011) .This study... Continue Reading

AbSTRACT This research work is based on the construction of control chart for quality characteristics of Coke liquid (Sodium content, Sugar content and Volume) which may be used for control of future products of the Coca-Cola Company. Secondary data collected from Coca- Cola Company, Idokpa, Benin City Plant was analysed using Control Chart for... Continue Reading

AbSTRACT This research work is based on the construction of control chart for quality characteristics of Coke liquid (Sodium content, Sugar content and Volume) which may be used for control of future products of the Coca-Cola Company. Secondary data collected from Coca- Cola Company, Idokpa, Benin City Plant was analysed using Control Chart for... Continue Reading

ABSTRACT This work investigates and evaluates local liquid dielectric for insulation of power transformers. Considering the importance of transformer insulation the investigation is borne out of the need to develop the capacity for local production of transformer dielectric. Natural esters of vegetables origin have been found to have the suitable... Continue Reading